You are not logged in.
Pages: 1
This in NOT a program recommended for everyone. It is NOT that remarkable by itself. BUT can be very helpful as an anti-evil synergist when placed by a sensitive crafter.
I de-molded a bunch of pieces yesterday, and most have already found their way into various arrays and devices. This is all i have left.
It requires about 1 tsp each of fine tungsten powder and Epo Obo powder per pint of resin. More of these powders won't hurt anything but your wallet.
The epo obo is available on Joe's site. Tungsten is a bit pricey. The best deal i found was 1/2# for $30 on Amazon. And since tungsten is very heavy, the volume of 1/2# is small.
This is the only case so far where i've embedded objects into it. The larger square has about half its volume displaced by a large chunk of white qtz wrapped in the special tape. I had been using that stone for some time. It is very strong against AI.
Then i glued the top piece over it. The top piece has no imbedded objects.
Free program available from ChemmerBuster.
Online
Pages: 1